Yleiskatsaus
Pikatiedot
- Alkuperäpaikka:
-
Zhejiang, Kiina
- Tuotemerkki:
-
EPT
- Vaihdejärjestely:
-
Mato
- Lähtömomentti:
-
90-4000 (N.m)
- Syöttönopeus:
-
≤1500(RPM)
- Lähtönopeus:
-
≤146(RPM)
- certification:
-
ISO9001:2008
- Kotelon materiaali:
-
cast iron housing
- Vaihteiston materiaali:
-
20CrMnTi
- Shaft material:
-
45 Steel
- Tulostemuoto:
-
solid shaft , hollow shaft
Toimituskyky
- Toimituskyky:
- 1000 Set/Sets per Month
Pakkaus ja toimitus
- Pakkaustiedot
- 2)Vent Cap
3)Wooden Case”>1)Plastic Cover Inside
2)Vent Cap
3)Wooden Case
- Portti
- NINGBO/SHANGHAI
-
Läpimenoaika
: -
Määrä (sarjat) 1 – 35 >35 Arvioitu aika (päivinä) 40 Neuvoteltavana
Online-räätälöinti
Videon kuvaus
Tuotekuvaus
Point 1——Characteristics:
XINGHAI WANG reductors are based on the building block design. It’s convenient for them to fit all types of motors or to connect with other power input.
The same type of reductors can fit motors with different power. It’s possible for combinating and connecting of different machines.
1.High transmission efficiency. A single machine can reach up to 96%.
2.Precise division of transmission ratio with a wide range. The combination of machines can produce a larger transmission ratio at a low output rotational speed.
3.Various ways of installation. Horizontal installation at any position or flanged installation.
Point 2——Working Environment:
1.Working temperature: -40℃~50℃ (The lubrication should be heated until above 0℃ if work below 0℃)
2.The working place should be less than 1,000 meters above sea level.
3.The input rotational speed should not exceed 1800 r/min. The circumferential speed of the gear should not over 20meter/s.
4.Suitable for normal-reverse rotation.
5.Without industry limitation.
6.Please consult our technical supporting department for other circumstances.
Point 3——Lubricants Selection:
Reducer proper viscosity lubricating oil must be added before running, to make the friction between the gears, meeting the high load and impact load and let speed reducer play well on fuctions.
1.Put out the lubricants after using 200 hours.
2.Rinse
3.Rejoined the new oil to the center
Note: Oil level should not be too high or too low, otherwise, will increase the working temperature.
why choose us
Palvelumme
K1: Oletko kauppayhtiö vai valmistaja?
A1: We are manufacturer.
Q2:What kind of gearboxes you can provide?
A2:There is helical gearbox, helical-worm gearbox, helical-bevel gearbox, parallel gearbox, cycloidal gearbox, cylinder speed reducer, small worm wheel speed reducer, shaft-mounted speed reducer, planetary speed reducer, helical cone speed reducer, torque gearbox and so on.
Q3:How about the MOQ for your gearbox?
A3:We can accept 1 piece for sample for your testing.
Q4:What is your After-Sale Service?
A4:We supply free maintenance in warranty of one year.
