Pregled
Kratki detalji
- Mjesto porijekla:
-
Zhejiang, Kina
- Naziv robne marke:
-
EPT
- Raspored zupčanika:
-
Crv
- Izlazni obrtni moment:
-
19-2371N.m
- Ulazna brzina:
-
1500 o/min
- Izlazna brzina:
-
14-186rpm
- Primjenjive industrije:
-
Manufacturing Plant, Construction works, Energy & Mining
- Ležaj:
-
C&U
- Materijal kućišta:
-
Livenje željeza
- Položaj montaže:
-
Foot mounted, flange mounted
- Oil seal:
-
NAK
- Veličina:
-
40-250
- Rtio:
-
10,15,20,25,30,40,50,60
- Material of Shaft:
-
chromium steel
- Izlazni obrazac:
-
Solid shaft, hollow shaft
- Boja:
-
Green,yellow or according to arequirment.
Pakovanje i dostava
- Prodajne jedinice:
- Jedna stavka
- Veličina pojedinačnog pakovanja:
- 15X15X15 cm
- Bruto težina pojedinačno:
- 4.5 kg
- Vrsta paketa:
- cartons&wooden cases or according to customer's requirement
-
Vrijeme isporuke
: -
Količina (komad) 1 – 10 >10 Procijenjeno vrijeme (dani) 15 Za pregovore
Online prilagođavanje
Opis videa
FEATURS:
1.widely used in turbines, shaft liners and axletrees;good resistance to wear, with high precision in dimensions,low noise, advanced centric runningcastings.
2.With air vent and highprecision.
3.The structure is compact and the weight is large.
4.Packing:wooden cases or can be according to customer’s requriements.
NOTICE:
1. notice of installation
1.1 The base-plate must be plane and stoutness and the base-plate must be screwed down and shock proof.
1.2 The connecting shaft of prime mover, reducer and operation device must be coaxial installation.
1.3 The diameter tolerance zone of input and output shaft is H6, the holes of fittings( such as couplings, belt-pully, sprocket wheel and so on) must properly mate the shaft, which prevents bearing from breakage because of over-loose mate.
1.4 Drivers such as sprocker wheel and gear must be fitted close to bearings in order to reduce bending stress of hanging shaft.
1.5 While assembling motor of WPD reducer, it is necessary that proper amount of butter applies to the warm shaft input hole and keyway, avoiding assembling too tightly and rusting after using for a long time.
2.notice of usage2.1 Before using,please check carefully whether the reducer modle, distance, ratio, input connecting method , output shaft structure, input and output shaft direction and revolving direction accord with required.
| Ležaj | C&U |
| Material of Housing | Livenje željeza |
| Položaj montaže | Foot mounted, flange mounted |
| Uljni semering | NAK |
| Veličina | 40-250 |
| Rtio | 10,15,20,25,30,40,50,60 |
| Material of Shaft | chromium steel |
| Output Form | Solid shaft, hollow shaft |
| Boja | Green,yellow or according to arequirment. |
