Energy UNITS FOR LIFT TABLE

Energy UNITS FOR LIFT TABLE 1
Standard Description
This electrical power unit is designed solely for the modest lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit is broadly made use of in the field of logistic gadgets for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is managed through the solenoid valve using the velocity managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
General Description
This energy unit is made exclusively for the medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as the velocity controlled through the adjustable needle valve. When the lift rises to a substantial positoin, but the electrical power supply is cut, the lowering movement is controlled from the guide override function.
Power UNITS FOR LIFT TABLE 3
Basic Description
This electrical power unit is built exclusively for your large lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve and the speed controlled by a pressure compensated flow management valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This electrical power unit is built exclusively for the large lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve along with the speed managed from the adjustable needle valve. When the lift rises to a substantial positoin, but the power supply is cut, the lowering motion is managed from the guide override perform.
Particular Notes
one. This power unit is of S3 duty cycle, which could only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all the hydraulic parts concerned prior to installation of the electrical power unit.
3. Viscosity on the oil shoud be 15~46 cst,which really should also be clean and cost-free of impurities.N46 hydraulic oil is proposed.
4. Oil changing is needed soon after the original 100 operation hrs,afterwards when every single 3000 hours.
five. The electrical power unit shown is built to be mounted vertically.